Actions

Difference between revisions of "Turbine Compact Board Connectors"

From Zenitel Wiki

(Created page with "==PCB - Front== 500px <br style="clear:both;" /> '''P1''' RJ45 PoE port for 10/100 Mbit Ethernet connection. :The station can be powered from...")
 
(Output Connectors + 1 relay)
Line 58: Line 58:
  
 
The 5,3V output can deliver 200mA current maximum
 
The 5,3V output can deliver 200mA current maximum
 +
 +
See also [[Turbine Compact and MRBD]]
  
 
==PCB - Rear==
 
==PCB - Rear==

Revision as of 08:52, 12 October 2016

PCB - Front

TCIS Connections 3.PNG


P1 RJ45 PoE port for 10/100 Mbit Ethernet connection.

The station can be powered from this port if the line supports Power over Ethernet (PoE).
TCIS Connections 4.PNG



P2 6-pin plug-on terminal for external connections.

TCIS Connections 5.PNG


Pin 1/2 24 VDC for external secondary power if PoE is not used. Pin 1 is positive.
Pin 3 COM relay
Pin 4 NO relay
Pin 5 NC relay
The relay can switch and carry continuously 60W power maximum. 
So with maximum current 2A, it can take maximum 30V, or with maximum voltage 250VAC it can take maximum 240mA.

P4 Loudspeaker & Electret microphone

TCIS Connections 7.PNG


Pin 1 10W Speaker amplifier +
Pin 2 10W Speaker amplifier -
Pin 3 Electret Microphone +
Pin 4 Electret Microphone -

Note: To enable the electret microphone input when using a TKIS-2, the "Frontboard" must be set to "Kit" under Station Main Settings in the web interface of the device.

P3 10-pin plug-on terminal for external connections.

TCIS Connections 6.PNG
Pin 1 5.3V (max. 200mA current)
Pin 2 GND
Pin 3 Button Input or LED Driver
Pin 4 Button Input or LED Driver
Pin 5 Button Input or LED Driver
Pin 6 Button Input or LED Driver
Pin 7 Button Input or LED Driver
Pin 8 Button Input or LED Driver
Pin 9 600 ohm balanced line out +
Pin 10 600 ohm balanced line out -


Output Connectors + 1 relay

Connecting to the onboard relay. Extra LED controlled by output 1

The extra relay for any of the 6 I/O pins is connected as shown:

TurbineCompactOutputs.PNG

Most general purpose P-Channel MOSFET's should work. Recommended example: BSS84

The 5,3V output can deliver 200mA current maximum

See also Turbine Compact and MRBD

PCB - Rear

TCIS Connections 8.PNG


J6 10-pin terminal for digital MEMS Microphone

TCIS Connections 9.PNG
Pin 1 Left mic select (Vdd)
Pin 2 Right mic select (GND)
Pin 3 Data
Pin 4 Data
Pin 5 Vdd 3.3V
Pin 6 Vdd 3.3V
Pin 7 CLK
Pin 8 CLK
Pin 9 GND
Pin 10 GND


Front Board - Front

TCIS Connections 10.PNG


Front Board - Rear

TCIS Connections 11.PNG