Difference between revisions of "Vandal Resistant intercom - VR3G-1"
From Zenitel Wiki
(→Connectors, Indicators and Dimensions) |
(→Connectors, Indicators and Dimensions) |
||
| Line 30: | Line 30: | ||
*[[:Category:IMX28 Release notes|Software Release Notes]] | *[[:Category:IMX28 Release notes|Software Release Notes]] | ||
| − | ==Connectors | + | ==Connectors and Dimensions== |
| − | |||
*[[VR3G-1 and VR3G-1P Board Connectors|Board Connections]] | *[[VR3G-1 and VR3G-1P Board Connectors|Board Connections]] | ||
| − | |||
*[[VR3G-1 Dimensions|Dimensions]] | *[[VR3G-1 Dimensions|Dimensions]] | ||
Revision as of 15:47, 7 September 2023
Vandal Resistant intercom station for mounting in 3 gang backbox.
- 3mm (11 gauge) Stainless Steel
- Stainless steel call button
- Tested to IP66 and IK10
- Tamper switch
- Anti-ligature design
Contents
Getting started
Configuration
The station can operate in three different modes, depending on what kind of server the station should register to. Choose one of the links below according to what mode you need to configure.
General configuration:
Station specific configuration:
Restore Factory Defaults and Software Upgrade
- Restore Factory Defaults
- Upgrade via the station web interface
- Upgrade using the IMT tool
- Automatic Software Upgrade (SIP mode only)
- Software Release Notes
Connectors and Dimensions
Accessories
Software Requirements
This station is fully supported as from AlphaCom version 11.2.3.7