Actions

TCIx Connections

From Zenitel Wiki

Revision as of 09:43, 7 January 2013 by Roarl (talk) (PCB - Front)
TCIS Connections 1.PNG

This article describers all Turbine Compact IP Standard Station connections.

The Turbine Compact IP station has a RJ-45 PoE/LAN port, and 6-pin & 10-pin external connectors.

Ethernet/Power 10/100 Mbps Ethernet RJ-45 port for LAN (uplink) connection. Supports PoE (802.3af). Draws power from either spare line or signal line.
Secondary Power 24 VDC (16 – 48 V) secondary power is provided from an external adapter.
Relays There is one Double Throw relay contact with 60W switching power. COM, NO, NC contacts are provided. Max: 250VAC/220VDC, 2A, 60W.
Input/Output 6 I/Os are available. Each I/O can be configured as either input, output, or LED driver.
Audio Line Out A balanced 600 ohm audio line out with induction loop signal
Note! Use cables crimped with ferrules for terminal block connectors
  • When the Turbine Station is connected to the network, its IP address is automatically obtained from a DHCP server or an IP address in the range 169.254.x.x will be assigned.
  • To make the station speak its IP address, press the call button on the station.

TCIS Connections 2.PNG


PCB - Front

TCIS Connections 3.PNG


TCIS Connections 4.PNG

P1 RJ45 PoE port for 10/100 Mbit Ethernet connection.

The station can be powered from this port if the line supports Power over Ethernet (PoE).


TCIS Connections 5.PNG

P26-pin plug-on terminal for external connections.

Pin 1/2 24 VDC for external secondary power if PoE is not used. Pin 1 is positive.
Pin 3 COM relay
Pin 4 NO relay
Pin 5 NC relay


Input Connectors

TCIS Connections 6.PNG

P3 10-pin plug-on terminal for external connections.

Pin 1 5.3V
Pin 2 GND
Pin 3 Button Input or LED Driver
Pin 4 Button Input or LED Driver
Pin 5 Button Input or LED Driver
Pin 6 Button Input or LED Driver
Pin 7 Button Input or LED Driver
Pin 8 Button Input or LED Driver
Pin 9 600 ohm balanced line out +
Pin 10 600 ohm balanced line out -1


TCIS Connections 7.PNG

P4 Loudspeaker & Electret microphone

Pin 1 10W Speaker amplifier +
Pin 2 10W Speaker amplifier -
Pin 3 Electret Microphone +
Pin 4 Electret Microphone -


PCB - Rear

TCIS Connections 8.PNG

TCIS Connections 9.PNG

J6 10-pin terminal for digital MEMS Microphone

Pin 1 Left mic select (Vdd)
Pin 2 Right mic select (GND)
Pin 3 Data
Pin 4 Data
Pin 5 Vdd 3.3V
Pin 6 Vdd 3.3V
Pin 7 CLK
Pin 8 CLK
Pin 9 GND
Pin 10 GND


Front Board - Front

TCIS Connections 10.PNG


Front Board - Rear

TCIS Connections 11.PNG