Difference between revisions of "ECPIR-3P"
From Zenitel Wiki
(→Restore Factory Defaults and Software Upgrade) |
m (Added support for Pulse with link to DAK config in SIP/Pulse) |
||
| Line 1: | Line 1: | ||
| − | {{ | + | {{APS}}[[file:ECPIR-3PFront.PNG|right|400px]] |
== Getting started == | == Getting started == | ||
* [[ECPIR Connections|Connecting your Turbine Intercom station]] | * [[ECPIR Connections|Connecting your Turbine Intercom station]] | ||
| Line 10: | Line 10: | ||
** [[EBMDR-8 - Configuration|Configuration for Expansion Module EBMDB-8]] | ** [[EBMDR-8 - Configuration|Configuration for Expansion Module EBMDB-8]] | ||
* [[SIP Intercom Configuration|SIP mode]] (*) | * [[SIP Intercom Configuration|SIP mode]] (*) | ||
| + | ** [[Direct Access Key & Ringlist Settings (Pulse/SIP)]] | ||
* [[IP Station Configuration - Pulse mode|Pulse mode]] (*) | * [[IP Station Configuration - Pulse mode|Pulse mode]] (*) | ||
| + | ** [[Direct Access Key & Ringlist Settings (Pulse/SIP)]] | ||
:(*) SIP and Pulse mode is fully supported as from firmware version 4.7. | :(*) SIP and Pulse mode is fully supported as from firmware version 4.7. | ||
Revision as of 10:14, 25 September 2017
Contents
Getting started
Configuration
The station can operate in three different modes, depending on what kind of server the station should register to. Choose one of the links below according to what mode you need to configure.
- AlphaCom mode
- SIP mode (*)
- Pulse mode (*)
- (*) SIP and Pulse mode is fully supported as from firmware version 4.7.
Restore Factory Defaults and Software Upgrade
- Restore Factory Defaults
- Upgrade via the station web interface
- Upgrade using the IMT tool
- Automatic Software Upgrade (SIP mode only)
Connectors, Indicators and Dimensions
Accessories
| 100px | 
|
|
|
|
| EBMDR-8 | MB-30G | EMMAR-1H | EMBR-1 | EMBR-2 |
