HD audio for background music distribution

Feature 118

Background music is distributed by using the Audio Program feature of AlphaCom. By default this feature is using the HD Voice codec G.722.

In installations where an even better audio quality for background music distribution is required, it is possible to use the HD Audio codec PCM L16/48kHz.

The following devices support audio input feed using the PCM L16/48kHz codec:

• ENA Amplifier
• TKIE-2 kit

The following devices can play audio in PCM L16/48kHz format:

• ENA2200, ENA2400-AC and ENA2400-DC amplifiers

Requirements

Software

• HD Audio is supported from AMC 12.5.3.1 or later.

License:

• HD Audio for background music distribution requires a High bandwidth audio license. It is sufficient with one HD Audio license per AlphaCom server.
• If the Audio Input source is the Line Input of the ENA Amplifier, one ENA Amplifier Channel License is required
• To install the license, log on to the web interface of the AlphaCom server, and select System Configuration > Licensing.

Configuration

Configuration of ENA Amplifier

• Log In to the amplifier
• In Station Main > Main Settings enter a directory number to use for the Line Input:

Enter a directory number to use for the Line Input

• Enable the Line Input: In Amplifier Settings > Line Control > Line In section, set Line In Type = "Line Input", and set Impedance to High or 600 ohms (most common).

Configuration of TKIE-2

If a TKIE is used as Audio Program source, Audio Input Source must be set to "Line In":

Set "Audio Input Source" = Line In

Configuration of AlphaCom server

The Line Input channel of the ENA Amplifier (or the TKIE-2 kit) must register to a directory number in the AlphaCom server.

In AlphaPro Users & Stations, enter a directory number for the Line Input:

Create a Directory Number for "Line Input"

Create a feature code to become an Audio Source. From AlphaPro Directory & Features, press Insert and create a new directory number:

• Feature 118 - Program Source
• ID (Parameter 1) = Program channel 1-70
• Parameter 2 = 0
• Parameter 3 = 10 (PCM L16/48kHz codec)

The example below shows how to add directory number 6801 as the code to become the source of Audio Program #1.

A device dialing 6801 will become the source for Audio Program 1 (ID = Program channel)

Add an event that sets the Line Input of the ENA Amplifier (or TKIE-2) as audio program source. Use the event 13 (Faulty Station), When Change To = OFF, and action: $DD L%1.dir L6801.

The ENA Line Input dials 6801 after registration, and becomes the source for program #1

{{{1}}}

The Directory numbers used to listen to program is default numbers 801 - 806. The feature number 6801 is NOT for listening, it used to set the source for the program channel.

Use

• Audio Program selection
• Remote setup to other stations or groups/zones