Difference between revisions of "IP Station Configuration - Pulse mode"
From Zenitel Wiki
| Line 1: | Line 1: | ||
| − | {{P}}When an IP intercom station is to be used in a Pulse system, the only setting required is that the station is in "Pulse mode". "Pulse mode" is the default mode. If not sure, resetting the station to Factory Defaults will set it to this mode. | + | {{P}} |
| + | The "auto-discovery" feature of the Pulse Sys | ||
| + | |||
| + | Assuming that there is already a Pulse Server on the ntwork, these are the steps: | ||
| + | * Connect the IP Station to the network. Station are by default set to operate in Pulse Mode. If not sure, you can do a factory default of the station | ||
| + | * When the station has started up, the [[Pulse Server]] will automatically discover the station. | ||
| + | * Log on to the Pulse Server, and go to the Directory list. (. | ||
| + | |||
| + | Discovered stations are automatically shown in the stations list. Stations that are configured with some other server will be automatically deselected in the list. Only stations which are selected (checkbox enabled) will receive configured settings, and only those will be saved to Pulse server directory: if we deselect a previously configured station it will be removed from Pulse server directory. | ||
| + | |||
| + | Save will push the configuration to selected stations. | ||
| + | |||
| + | Apply will reboot the selected stations | ||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | When an IP intercom station is to be used in a Pulse system, the only setting required is that the station is in "Pulse mode". "Pulse mode" is the default mode. If not sure, resetting the station to Factory Defaults will set it to this mode. | ||
When the station is connected to the same network as the [[Pulse Server]] station, the station will automatically be discovered by the [[Pulse Server]], and further configuration (including IP settings) are done on the Pulse Server, which will push the settings to the station. | When the station is connected to the same network as the [[Pulse Server]] station, the station will automatically be discovered by the [[Pulse Server]], and further configuration (including IP settings) are done on the Pulse Server, which will push the settings to the station. | ||
Revision as of 14:59, 17 July 2017
The "auto-discovery" feature of the Pulse Sys
Assuming that there is already a Pulse Server on the ntwork, these are the steps:
- Connect the IP Station to the network. Station are by default set to operate in Pulse Mode. If not sure, you can do a factory default of the station
- When the station has started up, the Pulse Server will automatically discover the station.
- Log on to the Pulse Server, and go to the Directory list. (.
Discovered stations are automatically shown in the stations list. Stations that are configured with some other server will be automatically deselected in the list. Only stations which are selected (checkbox enabled) will receive configured settings, and only those will be saved to Pulse server directory: if we deselect a previously configured station it will be removed from Pulse server directory.
Save will push the configuration to selected stations.
Apply will reboot the selected stations
When an IP intercom station is to be used in a Pulse system, the only setting required is that the station is in "Pulse mode". "Pulse mode" is the default mode. If not sure, resetting the station to Factory Defaults will set it to this mode.
When the station is connected to the same network as the Pulse Server station, the station will automatically be discovered by the Pulse Server, and further configuration (including IP settings) are done on the Pulse Server, which will push the settings to the station.
See here How to set up a Pulse System.