Difference between revisions of "IP Station Configuration - Pulse mode"

Revision as of 15:08, 17 July 2017

Assuming that there is already a Pulse Server on the network, follow these steps to add a new station to an existing Pulse System:

Connect the new IP Station to the network. Stations are by default set to operate in Pulse Mode. If not sure, you can do a factory default of the station
Wait for the station to boot up (approximately 60 seconds). When the station has started up, the Pulse Server will automatically discover the station.
Log on to the Pulse Server station (not to the new station!)
Select Server Management > Server Configuration > Directory Settings. The new station should now appear in the station list.
To identify the station, click Play. You will now hear a tone in the loudspeaker of the station you selected.
Enter Directory number, Name and IP address for the station. You can choose to use a static IP address or to obtain IP address from a DHCP server.
Click Save to push the new settings to the stations, and Apply to do a required system reboot.

Configure the Server Directory

If you need to set up a Pulse System from start, see Pulse Configuration.

@@ Line 13: / Line 13: @@
+If you need to set up a Pulse System from start, see [[Pulse Configuration]].
-Discovered stations are automatically shown in the stations list. Stations that are configured with some other server will be automatically deselected in the list. Only stations which are selected (checkbox enabled) will receive configured settings, and only those will be saved to Pulse server directory: if we deselect a previously configured station it will be removed from Pulse server directory.
-Save will push the configuration to selected stations.
-Apply will reboot the selected stations
-When an IP intercom station is to be used in a Pulse system, the only setting required is that the station is in "Pulse mode". "Pulse mode" is the default mode. If not sure, resetting the station to Factory Defaults will set it to this mode.
-When the station is connected to the same network as the [[Pulse Server]] station, the station will automatically be discovered by the [[Pulse Server]], and further configuration (including IP settings) are done on the Pulse Server, which will push the settings to the station.
-See here [[Pulse Configuration|How to set up a Pulse System]].