Difference between revisions of "M-key (Event Type)"
From Zenitel Wiki
| Line 1: | Line 1: | ||
| + | ==Event description== | ||
| + | {| | ||
| + | |- | ||
| + | |width="100pt"|'''Event Owner''': | ||
| + | |width="300pt"|A station or an [[UDP]] group | ||
| + | |- | ||
| + | |'''Event type''': || 13 - Faulty station line | ||
| + | |- | ||
| + | |'''Subevent''': || N/A | ||
| + | |- | ||
| + | |'''When change to ON''': || A station's line monitoring has found a problem or if the whole ASLT board becomes faulty | ||
| + | |- | ||
| + | |'''When change to OFF''': || A station's line monitoring has found the station OK | ||
| + | |- | ||
| + | |'''When related to''': || N/A | ||
| + | |- | ||
| + | |} | ||
| + | <br> | ||
| + | |||
| + | == Application== | ||
| + | Switch over a PA-system to a standby circuit | ||
| + | |||
| + | == Additional information == | ||
| + | There is also a default "Faulty Line" event, which becomes active if one more stations are faulty. This event is used for general line error reporting. The reporting is configured from AlphaPro, Exchange & System -> RCI -> Faults: Faulty Line. Default setting is [[MST - Mail to Station|MST]] 1 0 28, which is by reporting line errors (28) to station 1. | ||
| + | |||
| + | |||
| + | |||
| + | [[Category:Event Handler]] | ||
| + | |||
| + | |||
| + | |||
==Event description== | ==Event description== | ||
Revision as of 02:22, 4 November 2007
Event description
| Event Owner: | A station or an UDP group |
| Event type: | 13 - Faulty station line |
| Subevent: | N/A |
| When change to ON: | A station's line monitoring has found a problem or if the whole ASLT board becomes faulty |
| When change to OFF: | A station's line monitoring has found the station OK |
| When related to: | N/A |
Application
Switch over a PA-system to a standby circuit
Additional information
There is also a default "Faulty Line" event, which becomes active if one more stations are faulty. This event is used for general line error reporting. The reporting is configured from AlphaPro, Exchange & System -> RCI -> Faults: Faulty Line. Default setting is MST 1 0 28, which is by reporting line errors (28) to station 1.
Event description
| Event Owner: | A station or UDP group |
|---|---|
| Event type: | 31 - M-key |
| Sub-Event: | Sub Event = 0 will give M key status when station is busy.<br\>Sub Event = 1 will give M key status when station is idle. |
| When Change to ON: | M key press |
| When Change to OFF: | M key release |
| When Related to: | N/A |