Difference between revisions of "M-key (Event Type)"
From Zenitel Wiki
(→Event description) |
|||
| Line 7: | Line 7: | ||
|'''Event type''': || 31 - M-key | |'''Event type''': || 31 - M-key | ||
|- | |- | ||
| − | |'''Subevent''': || | + | |'''Subevent''': || 0: will give M key status when station is busy.<br\>1: will give M key status when station is idle. |
|- | |- | ||
|'''When change to ON''': || M key pressed | |'''When change to ON''': || M key pressed | ||
Revision as of 02:30, 4 November 2007
Event description
| Event Owner: | A station or an UDP group |
| Event type: | 31 - M-key |
| Subevent: | 0: will give M key status when station is busy.<br\>1: will give M key status when station is idle. |
| When change to ON: | M key pressed |
| When change to OFF: | M key released |
| When related to: | N/A |
Application
Switch over a PA-system to a standby circuit
Additional information
There is a default "Faulty Line" event which becomes active if one more stations are faulty. This event is used for general line error reporting. The reporting is configured from AlphaPro, Exchange & System -> RCI -> Faults: Faulty Line. Default setting is MST 1 0 28, which is by reporting line errors (28) to station 1.
Event description
| Event Owner: | A station or UDP group |
|---|---|
| Event type: | 31 - M-key |
| Sub-Event: | Sub Event = 0 will give M key status when station is busy.<br\>Sub Event = 1 will give M key status when station is idle. |
| When Change to ON: | M key press |
| When Change to OFF: | M key release |
| When Related to: | N/A |