View source for Play a customized audio message during ringing

This article describes how a customized ringing signal can be played in the receiving loudspeaker during the ringing sequence.

'''Hardware requirement:''' Black AMC-IP board (AMC11).

The ringing signal must be available as an audio file in wav format. The file must be [[Audio_Messaging#Upload_customized_wav-files_from_AlphaWeb|uploaded to the AMC-IP as an alarm message]]. A basic or enhanced [[Licenses#Audio_Messaging_License|audio message license]] is required.

In [[AlphaPro]], go to [[Exchange_%26_System_%28AlphaPro%29#Events|Exchange and System -> Events]], press Insert and create the following event:
------------
{| 
|-
|width="100pt"|'''Event Owner''':
|width="400pt"|Stations w/ UDP, Id: 8 (all stations)
|-
|'''Event type''': || [[Private Ringing mode (Event Type)|09 - Private Ringing mode]]
|-
|'''When change to''': || ON or OFF
|-
|'''When related to''': || All
|-
|'''Action:''' || [[AMS]] %1.phy %chg(3,0)
|-
|}

------------
When a station is called and starts to ring, alarm message number 3 will be played in the speaker. The message will repeat it self until the call is answered, or the ringing times out. Alarm messages are using [[Volume and handset override|volume override]] by default, so the message will be played at maximum output level.


If a customized ringing signal should be played in the loudspeaker of the initiator this event must be used:
{| 
|-
|width="100pt"|'''Event Owner''':
|width="400pt"|Stations w/ UDP, Id: 8 (all stations)
|-
|'''Event type''': || [[Private Ringing Outgoing (Event Type)|33 - Private Ringing Outgoing]]
|-
|'''Suevent''': || 255
|-
|'''When related to''': || All
|-
|'''Action:''' || [[AMS]] %1.phy %chg(3,0)
|-
|}

[[Category:Applications]]