View source for Cold Start of AMC-IP

{{A}}
Performing a '''cold start''' of the AMC-IP board will delete all previous programming, load factory default settings and set the IP-address to 169.254.1.5 with mask 255.255.0.0 on Eth0.

===Cold start procedure===
[[Image:Cold Start of AMC-IP.jpg|right|130px|thumb|Cold start to load default factory settings]]
*Turn the exchange mains switch ON (on the back of the cabinet).
*Hold the [[AMC-IP#LED indicators|cold start button]] on the [[AMC-IP]] board depressed.
*Press the reset button on the [[APC]] card briefly. (On the E7 exchange, the reset button is located on the power card.)
*Keep the cold start button pressed at least 2 sec. after reset. The AMC status LED will blink green when the boot is ready.

<br/><br/>
=== Cold-start of AMC application only, keep IP setting ===
[[Image:Cold Start of AMC-IP.2.jpg|right|130px|thumb|Cold-start of AMC application]]
*Press the reset button on the APC card briefly. (On the E7 exchange, the reset button is located on the power card.)
*After 10 sec., press the cold start button on the AMC-IP board.
*Keep cold start button pressed until AMC running LED is blinking green.
><br/><br/>

== Modify Factory Default Settings ==
After cold start the system is set up with a default program and is working without any further programming. To change or add to the default settings, the [[AlphaPro]] programming tool must be used.

[[Category:Factory Default]