View source for IP-ARIO Connections

{{A}}
==Installation==
The table below is an overview of the main connections involved when installing the IP-ARIO unit.
{| border="1" 
|-
| LAN || 10/100 Mbps RJ45 port for LAN (uplink) connection. Supports PoE (802.3af). Draws power from either spare line or signal line.
|-
| AUX || 10/100 Mbps RJ45 port for auxiliary equipment such as PC and IP camera.
|-
| RS232 || RJ45 port (pinout: 3=TX, 4&5=GND, 6=RX)
|-
| PA Interface || Dual Balanced 600 Ohm 0dB audio out (adjustable 0 to -10 dB)
|-
| Radio Interface || Single 600 Ohm 0dB audio in/out (adjustable 0 to -10 dB)
|-
| Digital Inputs || 8 inputs (Input 1 and 2 is referred to GND, input 3 to 8 is shorting or referred to GND)
|-
| Digital Outputs || 8 relay outputs (Output 1 - 4 is closing contact, output 5 - 8 is change-over contact). 60W switching capacity
|-
| Local Power || Pluggable screw terminal, 19-27 VDC Idle 4W, max. 8W
|-
|}

==Power Supply==
The IP-ARIO unit supports Power over Ethernet (PoE,IEEE 802.3af) where power can be drawn from either the spare or signal line. If PoE is not available, the IP-ARIO unit can be connected to a local power supply of 24 VDC.

==Network Connection==
[[File:IP-ARIOrear.PNG|thumb|left|500px|IP-ARIO rear view]]
<br style="clear:both;" />

There are three RJ45 ports at the rear of the IP-ARIO unit:
* '''LAN''' port is for connecting to the network and the AlphaCom server/exchange.
* '''AUX''' port is for connecting to auxiliary equipment such as a PC.
* '''RS 232''' port is for remote signalling

<br style="clear:both;" />

[[Category: INCA Connections]]