View source for Ascom IP-DECT

This article describes how to setup the Ascom IP-DECT to work to with the AlphaCom E using the SIP protocol.
[[Image:Ascom configuration example.jpg|thumb|left|Configuration example]]
<br style="clear:both;" />

=== Configuration of Ascom IP-DECT ===
Load factory default configuration on the IP-Dect unit by pressing the reset button through the hole at the rear with an unbend paper clip for 10 sec.

The Ethernet port is by default set to obtain an IP address automatically (DHCP) if connected to a LAN network with DHCP server. To access the embedded web server of the IP-Dect unit, start your internet browser and in the address field enter '''ipbs-xx-xx-xx''', where xx-xx-xx is the last six digits of the MAC address printed at the rear of the IP-Dect unit.

192.168.0.1




[[Image:Ascom log on.jpg|thumb|Ascom Webserver - Log on]]
<br style="clear:both;" />

[[Image:Ascom DHCP off.jpg|thumb|Switch DHCP off]]
<br style="clear:both;" />

[[Image:Ascom set IP address.jpg|thumb|Set IP address]]
<br style="clear:both;" />

[[Image:Ascom Base setup.jpg|thumb|Setup of Dect base]]
<br style="clear:both;" />

[[Image:Ascom Master base.jpg|thumb|Configure master base]]
<br style="clear:both;" />

[[Image:Ascom Base setup2.jpg|thumb|Base setup]]
<br style="clear:both;" />

[[Image:Ascom base SARI.jpg|thumb|Enter SARI]]
<br style="clear:both;" />

[[Image:Ascom Base sync mode.jpg|thumb|Set base sync mode]]
<br style="clear:both;" />

[[Image:Ascom new user.jpg|thumb|Add a new user]]
<br style="clear:both;" />

[[Image:Ascom all users.jpg|thumb|Show all users]]
<br style="clear:both;" />

[[Image:Ascom registration.jpg|thumb|Successful registration]]
<br style="clear:both;" />

=== Configuration of AlphaCom E ===



=== Related articles ===
[[Test report Ascom IP-Dect]]

[[Category:SIP]]