View source for IP Substation Indication LEDs

Indication LEDs
STATION LED (on board and in front plate)
Blinking 1 sec. interval 	Station does not have connection to the AlphaCom E exchange.
Possible reasons: 
- No connection to Ethernet 
- Wrong AlphaCom E IP address configured 
- Invalid IP address 
- No or wrong gateway to the AlphaCom E exchange 
Blinking 5 sec. interval	Station has connection to the AlphaCom E exchange, but has not 
			been registered. 
Reason: 
- Station has not been programmed in AlphaPro 
No blinking 
Possible reasons: 
- Station connected and registered to the AlphaCom E exchange - All OK 
- Station not powered up (if no other LEDs are active)
STATUS LED
Blinking 2 red + 1 green 	Station does not have connection to the AlphaCom E exchange 
Blinking 1 red + 2 green	Station has connection to AlphaCom E exchange, but has not been 
			registered 
Blinking 3 green		Station connected and registered in the AlphaCom E exchange 
LAN LEDs (on LAN and AUX RJ45-jacks):
Left green LED: 
- Steady light		Ethernet connection OK 
- Blinking		Ethernet traffic 
- No light		No Ethernet connection 
Right amber LED: 
- Light			100 Mbit Ethernet connection 
- No light		10 Mbit Ethernet connection