View source for 1-3c. IP Stations – SoftClient (solution)

[[File:1-3c config.PNG|left|thumb|450px|System configuration]]
<br style="clear:both;" />
__NOTOC__

=== Install and configure the SoftClient ===
* Download the file '''SoftClientSetup.msi''' from e.g. [[Downloads|Wiki download page]] or from Partnernet,  and install it on the PC
* If not already done, change the IP address of the PC to 10.1.10.90, and subnet mask 255.255.0.0
* Start the SoftClient, and select '''File''' -> '''Preferences''', and set these parameters:
[[File:1-3c solution1.PNG|thumb|left|250px|SoftClient: File -> Preferences window]]
<br style="clear:both;" />
* '''Save Settings'''
* Select '''Configure Audio Device''' to adjust speaker and microphone levels

===Configure the AlphaCom XE===
*In AlphaPro go to '''Users & Stations''', and select physical number 40; 140 Station 40
*Use the section on the right and change the configuration as follows:
[[File:1-3c solution2.PNG|thumb|left|400px|AlphaPro: Users & Stations window]]
<br style="clear:both;" />

* Send the changes to the AlphaCom XE
[[File:SendChg.PNG|400px]]

=== Troubleshooting ===
* If the SoftClient does not register, check the following:
** In AlphaWeb, System Configuration -> Filters, verify that port for '''IP Stations''' and '''VoIP Audio''' is enabled 
** In AlphaWeb, System Configuration -> Licenses, verify that there are licenses installed for the SoftClient
<br><br><br><br>

----

===Related articles ===
* [[1-3c. IP Stations – SoftClient (practice)]]

[[Category: AlphaCom practice]]