View source for Adding station to existing system (Edge)

{{E}}

== Set up an IC-EDGE System from start ==
If you need to set up an IC-EDGE System from start, including the Edge controller, see [[Getting Started (IC-Edge)]].

== Add a station to an existing IC-EDGE System ==
If there is an [[Edge Controller]] already on the network, the controller will automatically detect new stations connected to the network. There is normally no need to do any configuration in the new station itself.
[[File:Edge Discovery.PNG|thumb|right|500px|Configuring the Directory Settings in the Edge controller]]
Follow these steps to add a new station to an existing IC-EDGE System:
# Connect the new IP Station to the network. Stations are by default set to operate in Edge Mode. If not sure, you can do a factory default of the station
# Wait for the station to boot up (approximately 60 seconds). When the station has started up, the [[Edge Controller]] will automatically discover the station. 
# [[Logging into an IP Station|Log on to the '''Edge Controller''' station]] (not to the new station!)
# Select '''Edge Controller''' > '''System Configuration''' > '''Directory'''. The new station should now appear in the station list of the Edge Controller.
# To identify the station,  click '''Play'''. You will now hear a tone in the loudspeaker of the station you selected.
# Enter '''Directory number''', '''Name''' and '''IP address''' for the station. You can choose to use a static IP address or to obtain IP address from a DHCP server.
# Click '''Save''' to push the new settings to the stations.

[[Category: IC-EDGE Configuration]]
[[Category: Turbine Configuration]]
[[Category: INCA Station Configuration Guide]]