View source for DAK key programming not working after SendAll

{{AI}}
It can happen that DAK key programming disappears or that changes in DAK key programming don't take effect after SendChg/All. Specially databases that are upgraded from v.8.x/9.x to 10/11.x can be affected by this fault.

[[Image:Select_nodetype.png|thumb|Temporarily select Node Type 'AlphaCom']]
[[Image:Send_Get_Modules.png|thumb|All Modules should be selected]]

It can happen that the 'Send/Get Modules' flags are not set correctly, and this will cause the DAK key problems.

The procedure for getting the correct settings:
* Open '''AlphaPro''' -> '''Exchange''' '''& System''' -> '''System'''
* Temporarily set the Node Type to 'AlphaCom'. The Send/Get Modules will now be visible.
* Make sure that all Modules are checked the Send/Get Modules box.
* Set the Node Type back to 'AlphaCom E'
* Click OK to save changes


[[Category:AlphaPro Troubleshooting]]