View source for SET LOGICAL RCO

{{AI}}
{| border="1"
|-
!style="background:#ffdead;" width="90pt" colspan="2"|SET_LOGICAL_RCO
!style="background:#ffdead;" width="100pt"|0x006B
!style="background:#ffdead;" width="30pt"|107	
!style="background:#ffdead;" |AMC 07.00
|-
|colspan="2"|'''$SLRC W2 U1'''<br>'''$SLRC W2 U1 W10'''||colspan="3"|''Set RCO #2''<br>''Set RCO #2 for 1 second''
|-
|colspan="5"|Set or clear a logical [[RCO]].  Mapping between logical and physical [[RCO]] is done by the exchange receiving this message.
Note: [[COMMAND_RESPONSE]] is returned at the time the destination node receives the message, not after the RCO pin has been actually set/cleared. 
|-
|align=center|1||[[UINT2]]||colspan="3"|Logical [[RCO]] number.
|-
|align=center|2||[[UINT1]]||colspan="3"|New pin state:
0 = turn output off

1 = turn output on
|-
|align=center|3||[[UINT2]]||colspan="3"|Duration of pulse, in tenths of second. '''Optional''', '''new''' in '''AMC 10.03'''. If Duration parameter is present, and non-zero, the [[RCO]] state specified in previous parameter lasts for the specified time. After the time has expired, the [[RCO]] is toggled to the opposite state. If a new $SLRC message on the same [[RCO]] arrives while the pulse timer is running, the timer is canceled, and the new message determines the new [[RCO]] state. Duration = 0 means infinite duration.
|-
|colspan="2"|Response:	
|colspan="3"|[[COMMAND_RESPONSE]]
|-
|}


[[AlphaNet_Data_Protocol#Remote_Control|Back to AlphaNet message list]]

[[Category: ACDP messages]]