View source for Starting Up Turbine TFIX-V2 Station

{{AEIS}}[[File:TFIX-V2 Starting Up.png|thumb|right|400px|Connecting the PC and the TFIX-V2 station to a network switch]]
The Turbine EX Station (TFIX-V2) features an embedded web interface, which allows users to log in via a standard web browser. 

To access the station from your PC, the PC and the TFIX-V2 station have to be connected to a network switch:
# Connect the PC to the switch 
# Connect the Flowire FCDC-3 to the switch
# Connect the TFIX-V2 station to the FCDC-3 using two wires
# Connect 24-48VDC (48VDC recommended) to the Flowire FCDC-3
# The station will now start up
# After startup, an '''IP address''' is automatically obtained in one of two ways:
## An IP address is obtained from a '''DHCP server''' if there is one. 
## If there is no DHCP server, a random IP address in the range '''169.254.x.x''' will be assigned. 


== How to find the IP Address of the station ==
If the station is not registered to a server, it will speak its own IP address when you press the '''Call button''', a '''Digit key''' or a '''DAK key'''  on the station

At startup the station is by default set to operate in IC-Edge mode.

During commissioning, the station must be set to operate in the required mode. There are three modes of operation:
* '''ICX-AlphaCom mode''' - the station will register to an ICX-AlphaCom server
* '''SIP mode''' - the station will register to a SIP server
* '''IC-Edge mode''' - the station will register to a IC-Edge server

[[Category: Turbine - Restore Factory Defaults and Software Upgrade]]