View source for Zenitel Client IMT Configuration

{{EP}} 
In the special case of using VS-SDK for a Pulse-enabled project, Zenitel Client must be configured from the VS-IMT (Intercom Management Tool). The following settings are configurable:
* '''General Settings''': Directory Number, Display Name (Nickname on network), Server IP.
* '''Audio Settings''': Speaker and Microphone volume, Noise cancellation, Audio profile, Conversation mode.
* '''Call Settings''': Auto answer can be enabled.
* '''Other Settings''': Username and password.
See [[VS-IMT VS-SDK for Pulse System Setup]] for further details.
[[File:VS-Client IMT.PNG|thumb|500x500px|IMT Configuration of Zenitel Client|none]]

This type of configuration should only be used if VS-SDK for Pulse is needed in the system. The standard way of configuring the Zenitel Client is via the application’s '''Account''' settings and station web interface on the [[Edge Controller|IC-Edge Controller]] or Pulse Server device.

Note that ''Vingtor Stentofon ZAP Service'' needs to be running for this type of configuration. See [[Zenitel Client Installer]] for instructions about how to install ''Vingtor Stentofon ZAP Service.''
[[Category:Zenitel Client]]