Advanced Output handler (ENA in SIP mode)

Event Triggers

Possible Event Triggers are

Will trigger an event on received DTMF. The action will stay on until next event happens.

The station may in some situations have multiple calls, the active call is the call which has media/tone handling.

Can be filtered so it will only trigger event on certain conditions.

State: Ringing, Queued, In Call, On Hold
Directory Number: Can either directory number or a range for example 100-199
Direction: Incoming, Outgoing or Incoming/Outgoing

If the state In Call is selected, the output will stay set until the call has ended.

May match any call. Can for example be used to indicate that a call from a specific station 100 is calling.

Can filter so it only triggers the event on

State: Ringing, Queued, In Call, On Hold
Direction: Incoming, Outgoing or Incoming/Outgoing
Channel: Channel 1, Channel 2, Input Channel
Directory Number: Can either directory number or a range for example 100-199

If the state In Call is selected, the output will stay set until the call has ended.

Event is triggered if registration failed. The output action will be cleared on registration success.

Event is triggered when station goes back to Idle.

Action can be either to control Relay or Output, and multiple IO's can be controlled in the same Event.

States can be same as in basic relay handling: steady off, steady on, slow flash, fast flash and timed steady on.

Event action operation

In this example the Relay will only be triggered if the station is in or attempting a call to the number 911.

Relay during call - example