Difference between revisions of "1-3c. IP Stations – SoftClient (solution)"

Revision as of 16:30, 22 March 2011

System configuration

Download and install the file SoftClientSetup.msi from e.g. AlphaWiki or from Partnernet
Assign to the PC the IP address 10.1.10.2, and subnet mask 255.255.0.0
Step to the menu selection IP Settings and enter the following parameters (IPgw is not relevant here):

Off-line menu: IP settings

When prompted, Save the changes. When asked for "Restart now" you can select "No".
Step to the menu selection AlphaCom IP and enter the following parameters:

Off-line menu: AlphaCom settings

In AlphaPro go to Users & Stations, and select physical number 40; 140 Station 40
Use the section on the right and change the configuration as follows:

AlphaPro: Users & Stations window

In AlphaPro go to Users & Stations, and select physical number 38; 138 Station 38
Use the section on the right and change the configuration as follows:

AlphaPro: Users & Stations window

If the SoftClient does not register, check the following:
- In AlphaWeb, System Configuration -> Filters, verify that port for IP Stations and VoIP Audio is enabled
- In AlphaWeb, System Configuration -> Licenses, verify that there are licenses installed for the SoftClient

@@ Line 5: / Line 5: @@
 === Install and configure the SoftClient ===
 * Download and install the file '''SoftClientSetup.msi''' from e.g. AlphaWiki or from Partnernet
-* Select '''Setup''' to enter the off-line menu. Password: 1851
+* Assign to the PC the IP address 10.1.10.2, and subnet mask 255.255.0.0
 * Step to the menu selection '''IP Settings''' and enter the following parameters (''IPgw'' is not relevant here):
 [[File:1-3a solution1.png|thumb|left|250px|Off-line menu: IP settings]]