Difference between revisions of "1-3c. IP Stations – SoftClient (solution)"

Revision as of 16:40, 22 March 2011

System configuration

Download the file SoftClientSetup.msi from e.g. AlphaWiki or from Partnernet, and install it on the PC
Change the IP address of the PC to 10.1.10.2, and subnet mask 255.255.0.0
Start the SoftClient, and select File -> Preferences, and set these parameters:

Off-line menu: IP settings

In AlphaPro go to Users & Stations, and select physical number 40; 140 Station 40
Use the section on the right and change the configuration as follows:

AlphaPro: Users & Stations window

In AlphaPro go to Users & Stations, and select physical number 38; 138 Station 38
Use the section on the right and change the configuration as follows:

AlphaPro: Users & Stations window

If the SoftClient does not register, check the following:
- In AlphaWeb, System Configuration -> Filters, verify that port for IP Stations and VoIP Audio is enabled
- In AlphaWeb, System Configuration -> Licenses, verify that there are licenses installed for the SoftClient

@@ Line 9: / Line 9: @@
 [[File:1-3c solution1.PNG|thumb|left|250px|Off-line menu: IP settings]]
 <br style="clear:both;" />
-* When prompted, '''Save''' the changes. When asked for "Restart now" you can select "No".
+* '''Save settings'''
-* Step to the menu selection '''AlphaCom IP''' and enter the following parameters:
+* Select '''Configure Audio Device''' to adjust speaker and microphone leveles.
-[[File:1-3a solution2.png|thumb|left|250px|Off-line menu: AlphaCom settings]]
-<br style="clear:both;" />
-* When prompted, '''Save''' the changes.
-* Step to the menu selection '''Restart''' and activate a restart of the station
 ===Configure the AlphaCom XE===