Difference between revisions of "1-3c. IP Stations – SoftClient (solution)"
From Zenitel Wiki
(→Install and configure the SoftClient) |
(→Install and configure the SoftClient) |
||
| Line 7: | Line 7: | ||
* Change the IP address of the PC to 10.1.10.2, and subnet mask 255.255.0.0 | * Change the IP address of the PC to 10.1.10.2, and subnet mask 255.255.0.0 | ||
* Start the SoftClient, and select '''File''' -> '''Preferences''', and set these parameters: | * Start the SoftClient, and select '''File''' -> '''Preferences''', and set these parameters: | ||
| − | [[File:1-3c solution1.PNG|thumb|left|250px| | + | [[File:1-3c solution1.PNG|thumb|left|250px|SoftClient: File -> Preferences window]] |
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
* '''Save Settings''' | * '''Save Settings''' | ||
Revision as of 16:45, 22 March 2011
Install and configure the SoftClient
- Download the file SoftClientSetup.msi from e.g. AlphaWiki or from Partnernet, and install it on the PC
- Change the IP address of the PC to 10.1.10.2, and subnet mask 255.255.0.0
- Start the SoftClient, and select File -> Preferences, and set these parameters:
- Save Settings
- Select Configure Audio Device to adjust speaker and microphone levels
Configure the AlphaCom XE
- In AlphaPro go to Users & Stations, and select physical number 40; 140 Station 40
- Use the section on the right and change the configuration as follows:
- Send the changes to the AlphaCom XE
Troubleshooting
- If the SoftClient does not register, check the following:
- In AlphaWeb, System Configuration -> Filters, verify that port for IP Stations and VoIP Audio is enabled
- In AlphaWeb, System Configuration -> Licenses, verify that there are licenses installed for the SoftClient