Difference between revisions of "2-2d. Event Trigger - Event Handler (practice)"
From Zenitel Wiki
Line 1: | Line 1: | ||
− | |||
[[File:2-2d exercise.PNG|left|thumb|500px|System configuration]] | [[File:2-2d exercise.PNG|left|thumb|500px|System configuration]] | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
Line 20: | Line 19: | ||
− | |||
− | |||
− | |||
Revision as of 16:04, 29 October 2013
Exercise
Call setup:
- The Entrance and the SOS Point should be configured to make a Call Request (623 + 101) to the Control Room.
Set Call Request Forwarding:
- When dialing the event trigger number 9533, or when pressing a DAK key programmed to 9533 on the Control Room station, the following features should be activated:
- Turn on Call Request Forwarding from Control Room station 101 to station 103 (M. Larsen), so that all new call requests will be forwarded to station 103. Use the command "$SCRT" for this.
- Turn on a lamp (use RCO 3) to signal that call forwarding is active
- Write to the System LOG that the call forwarding has been activated. Use the LOG "..." statement.
Reset Call Request Forwarding:
- When dialing the event trigger number 9534, or when pressing a DAK key programmed to 9534 on the Control Room station, the following features should be activated:
- Turn off Call Request Forwarding for Control Room station 101. Use the command "$SCRT" for this.
- Turn off the lamp (RCO 3) to signal that call forwarding is not active
- Write to the System LOG that the call forwarding has been turned off. Use the LOG "..." statement.