Actions

Difference between revisions of "2-2d. Event Trigger - Event Handler (practice)"

From Zenitel Wiki

Line 1: Line 1:
{{stub}}
 
 
[[File:2-2d exercise.PNG|left|thumb|500px|System configuration]]
 
[[File:2-2d exercise.PNG|left|thumb|500px|System configuration]]
 
<br style="clear:both;" />
 
<br style="clear:both;" />
Line 20: Line 19:
  
  
Tip:
 
* Use AlphaWeb to upload a wav-file as alarm message 3, dir no 8193 (wav file is found on the memory stick)
 
* Use the $GM command to dispatch the message
 
  
  

Revision as of 16:04, 29 October 2013

System configuration


Exercise

Call setup:

  • The Entrance and the SOS Point should be configured to make a Call Request (623 + 101) to the Control Room.

Set Call Request Forwarding:

  • When dialing the event trigger number 9533, or when pressing a DAK key programmed to 9533 on the Control Room station, the following features should be activated:
    • Turn on Call Request Forwarding from Control Room station 101 to station 103 (M. Larsen), so that all new call requests will be forwarded to station 103. Use the command "$SCRT" for this.
    • Turn on a lamp (use RCO 3) to signal that call forwarding is active
    • Write to the System LOG that the call forwarding has been activated. Use the LOG "..." statement.

Reset Call Request Forwarding:

  • When dialing the event trigger number 9534, or when pressing a DAK key programmed to 9534 on the Control Room station, the following features should be activated:
    • Turn off Call Request Forwarding for Control Room station 101. Use the command "$SCRT" for this.
    • Turn off the lamp (RCO 3) to signal that call forwarding is not active
    • Write to the System LOG that the call forwarding has been turned off. Use the LOG "..." statement.








Related articles