2-2d. Event Trigger - Event Handler (solution)

System configuration

Solution

Call setup:

• The Entrance and the SOS Point should be configured to make a Call Request (623 + 101) to the Control Room.

Select the Entrance station in the list box, press DAK button, and enter "I 623 I 101" on DAK 1. Do the same for the SOS Point station.

• The Control Room should be configured as a CRM (Control Room Master), the DAK display should be enabled, and the Navigation Keys should be used for call queue navigations.

Select the Entrance station in the list box, press DAK button, and enter "I 623 I 101" on DAK 1. Do the same for the SOS Point station.

Select the Entrance station in the list box, press DAK button, and enter "I 623 I 101" on DAK 1. Do the same for the SOS Point station.

Select the Entrance station in the list box, press DAK button, and enter "I 623 I 101" on DAK 1. Do the same for the SOS Point station.

Set Call Request Forwarding:

• When dialing the event trigger number 9533, or when pressing a DAK key programmed to 9533 on the Control Room station, the following features should be activated:
  • Turn on Call Request Forwarding from Control Room station 101 to station 103 (M. Larsen), so that all new call requests will be forwarded to station 103. Use the command "$SCRT" for this.
  • Turn on a lamp (use RCO 3) to signal that call forwarding is active
  • Write to the System LOG that the call forwarding has been activated. Use the LOG "..." statement.

Reset Call Request Forwarding:

• When dialing the event trigger number 9534, or when pressing a DAK key programmed to 9534 on the Control Room station, the following features should be activated:
  • Turn off Call Request Forwarding for Control Room station 101. Use the command "$SCRT" for this.
  • Turn off the lamp (RCO 3) to signal that call forwarding is no longer active
  • Write to the System LOG that the call forwarding has been turned off. Use the LOG "..." statement.

---

Related articles

• 2-2d. Event Trigger - Event Handler (practice)