Difference between revisions of "Turbine Compact - Image recovery"
From Zenitel Wiki
(→Requirements) |
(→The USB to Serial cable) |
||
Line 25: | Line 25: | ||
* Pin 3 = Yellow (Turbine TX) | * Pin 3 = Yellow (Turbine TX) | ||
− | [[File:USB Serial orig.PNG|thumb|left| | + | [[File:USB Serial orig.PNG|thumb|left|200px|Original cable]] |
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
[[File:USB Serial mod.PNG|thumb|left|200px|Modified connector]] | [[File:USB Serial mod.PNG|thumb|left|200px|Modified connector]] | ||
<br style="clear:both;" /> | <br style="clear:both;" /> |
Revision as of 13:14, 17 December 2013
This article describes how the flash image of a Turbine Compact station can be recovered.
Before starting the upgrade process it is important to identify if the bootloader is corrupted or not.
- Corrupted bootloader
- The bootloader is intact
Requirements
- The application "Turbine Station Production Upgrade Application" installed on a Windows PC.
- A serial connection from the PC to the Turbine Compact board, using a USB to Serial cable
The USB to Serial cable
The Turbine station has a TTL level serial interface which we need to connect to during the upgrade process. For this purpose a USB to Serial converter cable can be used. Recommended cable is TTL-232R-3V3 from Farnell.
This cable needs to be slightly modified as per photo below:
- Pin 1 = Black (GND)
- Pin 2 = Orange (Turbine RX)
- Pin 3 = Yellow (Turbine TX)