IP Flush Connections

Introduction

The table below is an overview of the main connectors involved when installing the IP Flush Master Stations.

LAN	10/100 Mbps RJ-45 port for LAN (uplink) connection. Supports PoE (802.3af). Draws power from either spare line or signal line.
AUX	10/100 Mbps RJ-45 ports for auxiliary equipment such as PC and IP camera.
Handset Port	RJ11
Headset Port	RJ11
Input/Output	Pluggable screw terminal
Extension Unit (IP DAK-48)	RJ45
Local Power	Plugable screw terminal, 19-27 VDC Idle 4W, max. 8W

Power Supply

The IP Station supports Power over Ethernet (PoE, IEEE 802.3 a-f) where power can be drawn from either the spare line or signal line.

If PoE is not available, the IP Flush Master Station can be connected to a 24 VDC local power supply.

See Related Article IP Flush Master Station Board Connections for local power supply connections.

Network Connection

There are two RJ45 ports on the IP Stations:

• LAN port: for connecting to the network and the AlphaCom XE Audio Server.
• AUX port: for connecting to auxiliary equipment such as a PC or IP Camera.

IP Flush Master, IP OR, IP Master Kit - Rear view

Gooseneck Microphone for IP Dual Display

IP Dual Display Gooseneck Microphone

• Item number: 1007007010

This item applies to the IP Dual Display Station only.
To install the Gooseneck Microphone:

• Flip the station over so that the bottom side is facing up
• Slide the tab on the microphone foot into the slot on the side of the station
• Secure the microphone foot to the station with a screw as shown
• Plug the microphone jack into the socket just above the RJ45 port

Installing the Gooseneck Microphone for Dual Display

The internal microphone is automatically disconnected when the gooseneck microphone jack is inserted.

See also: IP Dual Display station: Noise from gooseneck mic

Input/Output Connections

There are I/O connection options for all IP Stations, except the IP Desktop Station and the IP Dual Display Station. These I/O connections include:

• 3 digital inputs (P4)
• 1 logical output (TP9)
• 1 relay output (P3)

These connections are used as relay contacts for door lock control and external I/O devices. For pin settings on the P3 and P4 connectors on the station board, see See Related Article IP Station Board Connections and Indications.