INCA Hotline LED Indicators: Difference between revisions
From Zenitel Wiki
(Created page with "====Station LED==== LED4 - Red 5mm LED on board rear side. This LED is on some models visible through the front plate, on others not. File:IP Hotline Station LED.PNG|left|t...") |
No edit summary |
||
| Line 1: | Line 1: | ||
== Station LED == | |||
LED4 - Red 5mm LED on board rear side. | LED4 - Red 5mm LED on board rear side. | ||
| Line 27: | Line 27: | ||
* Station not powered up (if no other LEDs are active) | * Station not powered up (if no other LEDs are active) | ||
== Status LED == | |||
LED3 – Bicolor SMD LED on board component side. | LED3 – Bicolor SMD LED on board component side. | ||
[[File:IP Master Indications 2.PNG|left|thumb|200px|Status LED]] | [[File:IP Master Indications 2.PNG|left|thumb|200px|Status LED]] | ||
| Line 40: | Line 40: | ||
* Station connected and registered in the AlphaCom XE Audio Server. | * Station connected and registered in the AlphaCom XE Audio Server. | ||
== Power LED == | |||
[[File:IP Master Indications 3.PNG|left|thumb|200px|Power LED]] | [[File:IP Master Indications 3.PNG|left|thumb|200px|Power LED]] | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
| Line 51: | Line 51: | ||
* Faulty board | * Faulty board | ||
== LAN LEDs == | |||
'''Left LED:''' | '''Left LED:''' | ||
[[File:IP Master Indications 4.PNG|left|thumb|200px|Left LED]] | [[File:IP Master Indications 4.PNG|left|thumb|200px|Left LED]] | ||
Revision as of 11:33, 25 October 2016
Station LED
LED4 - Red 5mm LED on board rear side.
This LED is on some models visible through the front plate, on others not.
Blinking at 1 second intervals:
Station has no connection to the AlphaCom XE Audio Server.
Possible reasons:
- No connection to Ethernet
- Wrong AlphaCom IP address configured
- Invalid IP address
- No gateway or wrong gateway to the AlphaCom XE Audio Server
Blinking at 5 second intervals:
Station connected but NOT registered in the AlphaCom XE Audio Server.
Possible reasons:
- Station has not been programmed in AlphaPro
- Missing IP Station license in AlphaCom XE Audio Server
No blinking:
Possible reasons:
- Station connected and registered to the AlphaCom XE Audio Server
- Station not powered up (if no other LEDs are active)
Status LED
LED3 – Bicolor SMD LED on board component side.
Blinking 2 red + 1 green:
- Station has no connection to the AlphaCom XE Audio Server.
Blinking 1 red + 2 green:
- Station connected but NOT registered in the AlphaCom XE Audio Server.
Blinking 3 green:
- Station connected and registered in the AlphaCom XE Audio Server.
Power LED
LED6 – Yellow SMD LED on board component side.
- Light: 13 V board power OK.
- No light: 13 V board power faulty if no other LEDs are lit.
Possible reasons:
- 24 VDC or PoE not connected
- Faulty board
LAN LEDs
Left LED:
- Steady light: Ethernet connection OK
- Blinking: Ethernet traffic
- No light: No Ethernet connection
Right LED:
- Light: 100 Mbit Ethernet connection
- No light: 10 Mbit Ethernet connection