Principles of Operation (AlphaCom)

Stentofon's intercom exchange AlphaCom is based on a new technology compared to previous systems. The two major changes in AlphaCom compared to Touchline is the speech coding used, and the fact that all actions in the exchange is based on messages on a 16 Mbit/s data bus. This makes the exchange fully digital internally. The purpose of this document is to describe the basic principles of the exchange and to give an overall view of the system. The different boards in the exchange are identified and described.

System Overview

Exchange

The AlphaCom intercom exchange is built up by one ore more modules. Each module can have a maximum of 138 subscribers. This number is heavily dependent on the number of other boards than subscriber line boards in the module. When the term exchange or AlphaCom is used, it refers to one or a number of interconnected modules.

Module

The module is based on a backplane carrying digital signals. This backplane interconnects the various parts of the system.

A module is the backplane fitted into a 19" cabinet. There are 26 slots (connections) to the backplane. The signals on the backplane can be divided into three sections.

• Audio channels. There are 16 TDM buses, thus giving a total of 256 timeslots in the system. These 16 buses are referred to as the audio bus.
• Data channels. There are two 16 Mbit/s serial data channel, the display data channel and a set of control and sync signals. These signals are referred to as the data bus.
• Power leads. A set of supply voltages.

The module can be equipped with different boards, each with a number of features and resources.

The boards of the module

Module Controller AMC

The AMC board is the key board in the system. This board is literally controlling the entire module. All connections, switching and routing is controlled by AMC. All the internal data-transfer and communication between the boards in the module is performed on one of the 16 Mbit serial data channels. The processor on AMC is linked to this serial bus by the Master Bus Interface (MBI).

Both the SBI and the MBI will be described separately. The other blocks are:

Tone Filters

All steady tones in the module are generated on AMC. The tones are generated by the MBI and by the DUARTs. Typical steady tones are tones that are available on the Audio Bus like Busy tone and Dial tone.

In addition to these tones there are a Attention Signal (GONG) generated by the DUARTs. All these signals are generated as square waves. These signals must be filtered to sine waves before they are modulated and switched to the Audio Bus by the SBI.

DTMF Generator

Some external equipment like pagers require DTMF signalling from the Module. The DTMF signals are modulated and switched to timeslots in the Audio Bus.

Watch Dog

The Watch Dog circuitry supervises the operation of the 68000 processor, as well as monitoring the power supply to the board.

Real time Clock

The Real time Clock has a Battery Back up. Used as a time reference in the module

DUART - Line drivers/receivers

4 Dual Asynchronous Receivers and Transmitters makes up the 8 serial ports to the module. Dependent on the drivers these ports will be RS232, RS422 or RS485.

Memory

The Memory Block consists of 5 different elements:

Standard Program Memory	This is 1Mbit EPROMs with the standard SW for the 68000
RAM	Parts of the RAM are battery backed, making it a Non-Volatile RAM. (NV-RAM). All subscriber information resides in RAM.
Two Port Ram	The communication between the 68000 and the MBI goes through a Two Port Ram.
Back-up memory	Flash-EPROM witch contains a subset of the information in the NV-RAM.
Plug-in-SW	Customer specific SW that operates on a defend set of resources in the module.