SDS-1

IP Phone SDS-1

Getting Started

Installing the Phone with Phone Stand

1. Insert the hooks on top of the stand into the slots on the back of the phone. (You can either use the upper OR the lower slots)
2. Firmly slide the stand upward to lock it in place

Installing the Phone with Wall Mount

1. Insert all 4 hooks located at the front of the wallmount into the slots on the back of the phone.
2. Firmly slide the wall mount upward to lock it in place.
3. Attach the phone to the wall via the wall mount holes.

1. Pull out the tab from the handset cradle (see figure below).
2. Rotate the tab and plug it back into the slot with the extension up to hold the handset while the phone is mounted on the wall.

Connecting the phone

1. Connect the handset and main phone case with the phone cord.
2. Connect the LAN port of the phone to the RJ-45 socket of a PoE switch using the Ethernet cable.
   The LCD will display provisioning or firmware upgrading information. Before continuing, please wait for the date/time display to appear.
3. Using the web configuration interface or the keypad configuration menu, you can further configure the phone using either a static IP or DHCP.

Configuration

The IP phone can only operate in SIP mode.

1. Ensure your phone is properly powered up and connected to the Internet.
2. Press the Menu key to enter the menu of the phone.
3. Navigate to Status > Network Status and press the Menu key to check the IP address.
4. Enter the phone’s IP address in your PC’s browser
5. Log in by entering the default Username: admin and Password: alphaadmin

Register the account on the SDS-1 by selecting ACCOUNTS > Account 1/2 > General Settings to configure Account Name, SIP Server (AlphaCom or Pulse), SIP User ID (Extension Number).

Register to AlphaCom server

Account setup

• Select ACCOUNTS > Account 1 > General Settings

Enter the values shown above for the parameters

• Account Active: Check Yes button
• SIP Server: IP address of AlphaCom server
• SIP User ID: Directory Number of SDS-1 phone
• Authenticate ID: Same as SIP User ID

For changes to take effect, it may be necessary to temporarily disable the account. First check the No button for Account Active, then click Save and Apply. Once this is done, re-enable the account by checking the Yes button for Account Active followed by Save and Apply again.

AlphaCom SDS-1 Audio Settings

• Check in AlphaPro under Users & Stations the codec that has been selected for the SIP phone (normally G722)
• Select Account 1 > Audio Settings

Set all codecs from the Preferred Vocoder list to the one defined in AlphaPro, i.e. G722.

Dimensions

• Phone dimensions

Front view

Right view

Rear view

• Bracket dimensions

Phone stand

Wall mount bracket

Related information

• Documentation on Zenitel.com