STATION EVENT BLOCK: Difference between revisions

Latest revision as of 15:11, 3 October 2019

STATION_EVENT_BLOCK		0x00B1	177
$SEB L101 U1 U1			Block M key from IP station
$SEB allow blocking of events from IP station (no analog stations) with $DP message. Note 1: Block state will always be cleared after reset. Note 2: Only station events kicked by DIP protocoll are blocked. Events from SimpleLinkLayer ($M, $MREL e.g) are not blocked during active blocking. Note 3: $DIAL_DAK is actually (AMC 11.2.3.3) using the DIP function to simulate DAK pressing. Based on this $DIAL_DAK is blocked also at SimpleLinkLayer
1	NET_OBJ_REF {ECL_USER}	Station to block
2	UINT1	Block event 1 = Block M-key from IP station 2 = Block Handset state from IP station 3 = Block Digit keys from IP station 4 = Block DAK keys from IP station 5 = Block C-key from IP station
3	UINT1	Block state 0 = Don't block event 1 = Block event
Response		none

@@ Line 1: / Line 1: @@
+{{AI}}
 {| border="1"
 |-
@@ Line 13: / Line 14: @@
 '''Note 3:''' $DIAL_DAK is actually (AMC 11.2.3.3) using the DIP function to simulate DAK pressing. Based on this $DIAL_DAK is blocked also at SimpleLinkLayer <br>
 |-
-|align=center|1||[[NET_OBJ_REF]]<br\>{[[ECL_USER]]} ||colspan="3"| Station to block
+|align=center|1||[[NET_OBJ_REF]]<br />{[[ECL_USER]]} ||colspan="3"| Station to block
 |-
 |align=center|2||[[UINT1]]||colspan="3"| Block event <br>