Physical number 5 and 6 (AlphaCom E7)

Physical numbers 5 and 6 in the AlphaCom XE7 can be used either as:

• Audio Program input, or
• For regular intercom stations

Audio Program input

By default the physical numbers 5 and 6 on the first ASLT line board in the AlphaCom XE7 are enabled for Audio Program distribution. The potmeters P5 and P6 are used to adjust the input level.

{{note|An ASLT card must be present in the 1st card position}

Intercom stations

By default phys no 5 and 6 are used for Audio Program input. However, it is possible to use these physical numbers for intercom stations instead. To enable physical number 5 and/or 6 to be used for regular intercom stations:

• Set jumpers P5 and/or P6 to position 1-2. There are five jumpers for P5, and five jumpers for P6. P5 is for physical port 5, and P6 is for physical number 6.

AlphaCom XE7 backplane

• In AlphaPro, select Exchange & System -> Boards
• Change the port setting from ‘Audio program feed’ to ‘Default’
• Reset the exchange

Set "Port Use" for physical number 5 and 6 to "Default"