Difference between revisions of "Physical number 5 and 6 (AlphaCom E7)"
From Zenitel Wiki
| (14 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| − | + | {{A}} | |
| + | Physical numbers 5 and 6 in the AlphaCom XE7 can be used either as: | ||
| + | * Audio Program input, or | ||
| + | * For regular intercom stations | ||
| + | == Audio Program input == | ||
| + | By default the physical numbers 5 and 6 on the first [[ASLT|ASLT line board]] in the [[AlphaCom XE7]] are enabled for Audio Program distribution. The potmeters P5 and P6 are used to adjust the input level. | ||
| − | + | {{Note|An ASLT card must be present in the 1st card position}} | |
| − | + | ||
| + | == Intercom stations == | ||
| + | By default phys no 5 and 6 are used for Audio Program input. However, it is possible to use these physical numbers for intercom stations instead. To enable physical number 5 and/or 6 to be used for regular intercom stations: | ||
| + | * Set jumpers P5 and/or P6 to position 1-2. There are five jumpers for P5, and five jumpers for P6. P5 is for physical port 5, and P6 is for physical number 6. | ||
[[Image:ACE7 backplane.jpg|thumb|300px|left|AlphaCom XE7 backplane]] | [[Image:ACE7 backplane.jpg|thumb|300px|left|AlphaCom XE7 backplane]] | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
| Line 14: | Line 22: | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
| − | |||
[[Category: AlphaCom Troubleshooting]] | [[Category: AlphaCom Troubleshooting]] | ||
[[Category: Station Troubleshooting]] | [[Category: Station Troubleshooting]] | ||
Latest revision as of 11:35, 27 August 2020
Physical numbers 5 and 6 in the AlphaCom XE7 can be used either as:
- Audio Program input, or
- For regular intercom stations
Audio Program input
By default the physical numbers 5 and 6 on the first ASLT line board in the AlphaCom XE7 are enabled for Audio Program distribution. The potmeters P5 and P6 are used to adjust the input level.
|
An ASLT card must be present in the 1st card position |
Intercom stations
By default phys no 5 and 6 are used for Audio Program input. However, it is possible to use these physical numbers for intercom stations instead. To enable physical number 5 and/or 6 to be used for regular intercom stations:
- Set jumpers P5 and/or P6 to position 1-2. There are five jumpers for P5, and five jumpers for P6. P5 is for physical port 5, and P6 is for physical number 6.
- In AlphaPro, select Exchange & System -> Boards
- Change the port setting from ‘Audio program feed’ to ‘Default’
- Reset the exchange
