Difference between revisions of "IP Flush Master Gooseneck"

Revision as of 13:28, 8 January 2021

Gooseneck Microphone. item no 1008097500

This microphone is for

To install the Gooseneck Microphone:

Remove the cover plug from the opening for the microphone on the front panel.
Thread the microphone cable through the opening, the lock washer and nut.
Tighten the nut on the microphone’s threaded stud.
Insert the microphone’s IDC socket into the upper two pins of the 3-pin header (J7) located at the lower left side of the station. The signal wire (white) should be on the top pin while the ground wire (green) should be on the bottom pin.
Slide the S1 switch (bottom back of station) to EXT to activate the external microphone function.

For board connectors, see:

Installing the Gooseneck Microphone

Gooseneck microphone connection

Gooseneck microphone connection, detailed

@@ Line 1: / Line 1: @@
-{{APS}}
+{{AEIPS}}
 [[File:1008097500.PNG|thumb|300px|Gooseneck Microphone. item no 1008097500]]
-This microphone is for the [[IP Flush Master - 1008031000|IP Flush Master Station]] and the [[IP Master Station Kit - 1008093000|IP Master Station Kit]].
+This microphone is for
+* [[IP Flush Master -V2]]
+* [[IP Flush Master - 1008031000|INCA IP Flush Master Station]]
+* [[IP Master Station Kit - 1008093000|INCA IP Master Kit]]
 To install the Gooseneck Microphone:
@@ Line 11: / Line 14: @@
 * Slide the '''S1''' switch (bottom back of station) to '''EXT''' to activate the external microphone function.
-For board connectors, see [[INCA Master Station Kit Board Connectors]].
+For board connectors, see:
+* [[INCA Master Station Kit Board Connectors]]
+* [[IP Flush Master Station Kit Board Connectors]]
 [[File:IP_Master_Gooseneck_Microphone_Installation.PNG|350px]]<br/>
@@ Line 26: / Line 31: @@
 [[Category: INCA Backboxes and accessories]]
+[[Category: Turbine Backboxes and accessories]]