Difference between revisions of "RESET DEVICE"
From Zenitel Wiki
| (5 intermediate revisions by 4 users not shown) | |||
| Line 1: | Line 1: | ||
| + | {{AI}} | ||
{| border="1" | {| border="1" | ||
|- | |- | ||
| Line 8: | Line 9: | ||
|colspan="5"|'''$RESET''' | |colspan="5"|'''$RESET''' | ||
|- | |- | ||
| − | |colspan="5"|Reset a device. Note that this also applies to the | + | |colspan="5"|Reset a device. Note that this also applies to the ICX-AlphaCom server. |
| − | The | + | The ICX-AlphaCom will do [[GET_DEVICE]] 1 second after RESET_DEVICE. If the external device is not able to do a hardware reset within this time, it’s OK to reset only the software for ICX-AlphaCom communication. |
|- | |- | ||
| − | |colspan=" | + | |colspan="4"|(no parameters)|| |
|- | |- | ||
|} | |} | ||
| Line 17: | Line 18: | ||
[[AlphaNet_Data_Protocol#Device_Control_and_Status|Back to AlphaNet message list]] | [[AlphaNet_Data_Protocol#Device_Control_and_Status|Back to AlphaNet message list]] | ||
| + | [[Category: DP Commands]] | ||
| + | [[Category: ACDP messages]] | ||
Latest revision as of 12:26, 30 June 2022
| RESET_DEVICE | 0x0039 | 57 | AMC 05.00 | |
|---|---|---|---|---|
| $RESET | ||||
| Reset a device. Note that this also applies to the ICX-AlphaCom server.
The ICX-AlphaCom will do GET_DEVICE 1 second after RESET_DEVICE. If the external device is not able to do a hardware reset within this time, it’s OK to reset only the software for ICX-AlphaCom communication. | ||||
| (no parameters) | ||||