Difference between revisions of "IP School Intercom Station Restore Factory Defaults"
From Zenitel Wiki
| (3 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
{{APS}} | {{APS}} | ||
| − | This procedure is applicable for the [[School IP Intercom - 1402001000 | + | {{note|This procedure is applicable for the [[School IP Intercom - 1402001000]].}} |
[[File:SchoolIndications1.png|right|300px]] | [[File:SchoolIndications1.png|right|300px]] | ||
'''Procedure:'''<br> | '''Procedure:'''<br> | ||
| Line 16: | Line 16: | ||
*Password: '''alphaadmin''' | *Password: '''alphaadmin''' | ||
| − | |||
| − | |||
[[Category: INCA - Restore Factory Defaults and Software Upgrade]] | [[Category: INCA - Restore Factory Defaults and Software Upgrade]] | ||
Latest revision as of 16:24, 31 January 2023
|
This procedure is applicable for the School IP Intercom - 1402001000. |
Procedure:
This procedure will load factory defalt settings in the station. The unit can be set to use either Static IP or DHCP.
- While pressing the emergency button, power up the station and keep the button pressed.
- Release the button after exactly 2 flashes of the LED.
- Let the LED flash for exactly 2 more times (Static IP) or exactly 4 more times (DHCP), then press the button again.
- Keep the button pressed until the LED flashes fast 2 times (Static IP) or flashes fast 4 times (DHCP) indicating a successful reset.
- Release the button and the station will restart with the factory default settings.
Factory default values:
- Station Mode: Pulse
- Station IP address: 169.254.1.100 (Static) or DHCP
- Username: admin
- Password: alphaadmin