Difference between revisions of "ICC Protocol"
From Zenitel Wiki
(New page: {{stub}} Category:AlphaCom E Software) |
(Unit numbers) |
||
Line 1: | Line 1: | ||
{{stub}} | {{stub}} | ||
+ | |||
+ | Inter Card Cage protocol is the protocol used between the master and the slave modules in a AlphaCom [[MultiModule]]. The ICC protocol provides very low level control of the HW resources in a AlphaCom module. | ||
+ | |||
+ | ==Parameter formats == | ||
+ | |||
+ | See | ||
+ | http://repository/repos/Products/AMC/design/AICE_doc/Converted%20from%20FrameMaker/icc_interface.pdf | ||
+ | |||
+ | === Unit numbers === | ||
+ | Unit numbers are used to refer to a audio channel on a SBI. In the ICC protocol unitnumbers are coded using one or two bytes. The bit layout of the variable “unit” parameter is: | ||
+ | |||
+ | Channel on first SBI, one byte like: | ||
+ | bbbbbccc | ||
+ | and for channels on higher SBIs two bytes like | ||
+ | 00000sss bbbbbccc | ||
+ | where | ||
+ | |||
+ | bbbbb is board number 1 – 26 | ||
+ | sss is the SBI number within the board, 0 - 7 | ||
+ | ccc is channel 0 – 7 with one SBI | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
[[Category:AlphaCom E Software]] | [[Category:AlphaCom E Software]] |
Revision as of 15:34, 28 September 2007
Inter Card Cage protocol is the protocol used between the master and the slave modules in a AlphaCom MultiModule. The ICC protocol provides very low level control of the HW resources in a AlphaCom module.
Parameter formats
See http://repository/repos/Products/AMC/design/AICE_doc/Converted%20from%20FrameMaker/icc_interface.pdf
Unit numbers
Unit numbers are used to refer to a audio channel on a SBI. In the ICC protocol unitnumbers are coded using one or two bytes. The bit layout of the variable “unit” parameter is:
Channel on first SBI, one byte like:
bbbbbccc
and for channels on higher SBIs two bytes like
00000sss bbbbbccc
where
bbbbb is board number 1 – 26 sss is the SBI number within the board, 0 - 7 ccc is channel 0 – 7 with one SBI