|
|
| (2 intermediate revisions by one other user not shown) |
| Line 1: |
Line 1: |
| == Introduction ==
| | {{APS}} |
| The table below is an overview of the main connectors involved when installing the IP DualDisplay Station. | | The IP DualDisplay station has one ethernet port: |
|
| |
|
| {|border="1"
| | * '''LAN''': 10/100 Mbps RJ-45 port for '''connection to the network'''. Supports Power Over Ethernet - PoE (802.3af). Draws power from either the spare pairs or from the signal line. |
| |width="150px"|LAN
| |
| |10/100 Mbps RJ-45 port for LAN (uplink) connection. Supports PoE (802.3af). Draws power from either spare line or signal line.
| |
| |-
| |
| |}
| |
|
| |
|
| == Power Supply ==
| | [[Image:IP_DualDisplay_Bottom_View.PNG|left|thumb|400px|IP Dual Display - Bottom view]] |
| The IP Station supports Power over Ethernet (PoE, IEEE 802.3 a-f) where power can be drawn from either the spare line or signal line.
| |
| | |
| == Network Connection ==
| |
| There is one RJ45 port located at the bottom of the IP Dual Display station that is used as the LAN port.
| |
| | |
| [[Image:IP_DualDisplay_Bottom_View.PNG|left|thumb|300px|IP Dual Display - Bottom view]] | |
| <br style="clear:both;" /> | | <br style="clear:both;" /> |
|
| |
|
| [[Category: INCA Connections]] | | [[Category: INCA Connections]] |
Latest revision as of 14:10, 5 February 2018
The IP DualDisplay station has one ethernet port:
- LAN: 10/100 Mbps RJ-45 port for connection to the network. Supports Power Over Ethernet - PoE (802.3af). Draws power from either the spare pairs or from the signal line.
IP Dual Display - Bottom view
