Actions

Difference between revisions of "IP-ARIO Connections"

From Zenitel Wiki

m (1 revision imported)
(No difference)

Revision as of 14:10, 5 February 2018

AlphaCom icon 300px.png

Installation

The table below is an overview of the main connections involved when installing the IP-ARIO unit.

LAN 10/100 Mbps RJ45 port for LAN (uplink) connection. Supports PoE (802.3af). Draws power from either spare line or signal line.
AUX 10/100 Mbps RJ45 port for auxiliary equipment such as PC and IP camera.
RS232 RJ45 port (pinout: 3=TX, 4&5=GND, 6=RX)
PA Interface Dual Balanced 600 Ohm 0dB audio out (adjustable 0 to -10 dB)
Radio Interface Single 600 Ohm 0dB audio in/out (adjustable 0 to -10 dB)
Digital Inputs 8 inputs (Input 1 and 2 is referred to GND, input 3 to 8 is shorting or referred to GND)
Digital Outputs 8 relay outputs (Output 1 - 4 is closing contact, output 5 - 8 is change-over contact). 60W switching capacity
Local Power Pluggable screw terminal, 19-27 VDC Idle 4W, max. 8W

Power Supply

The IP-ARIO unit supports Power over Ethernet (PoE,IEEE 802.3af) where power can be drawn from either the spare or signal line. If PoE is not available, the IP-ARIO unit can be connected to a local power supply of 24 VDC.

Network Connection

IP-ARIO rear view


There are three RJ45 ports at the rear of the IP-ARIO unit:

  • LAN port is for connecting to the network and the AlphaCom server/exchange.
  • AUX port is for connecting to auxiliary equipment such as a PC.
  • RS 232 port is for remote signalling