Difference between revisions of "GSM gateway (Mobile VoIP)"
From Zenitel Wiki
(→Configuration of the MV-370) |
|||
| Line 3: | Line 3: | ||
== Configuration of the MV-370== | == Configuration of the MV-370== | ||
| − | The default IP address | + | The MV-370 unit is configured via a web interface. The default IP address is 192.168.0.100. Before accessing the web page, confirm that the IP address of the configuration PC is on the same subnet, e.g. 192.168.x.x. |
| − | |||
*Username: voip | *Username: voip | ||
Revision as of 22:22, 5 March 2008
This article describes the setup of the GSM gateway MV-370 from PORTech Communications Inc
Contents
Configuration of the MV-370
The MV-370 unit is configured via a web interface. The default IP address is 192.168.0.100. Before accessing the web page, confirm that the IP address of the configuration PC is on the same subnet, e.g. 192.168.x.x.
- Username: voip
- Password: 1234
Route settings
Route:
- Route > Mobile to LAN Settings: CID = *, URL = *
This setting will give a second Dial-Tone on incoming calls to AlphaCom. The user must then dial the intercom number. The Mobile VoIP unit will connect the call 5 seconds after having received the last digit in the intercom number.
- Route > Mobile to LAN Settings: CID = *, URL = 101
With this setting incoming calls will automatically connect to station 101 in the AlphaCom.
Mobile settings
Mobile:
- Mobile > Settings > Mobile PIN Code: If the mobile needs to be unlocked by a pin code you must choose Enable, and enter the pin code, and confirm the pin code
- Mobile > Status: Shows that the SIM card in in place, and that the Mobil VoIP unit is registered on the GSM network.
Network settings
Network:
- Network > WAN Settings > IP Type = Enable "Fixed IP"
- Network > WAN Settings > IP = IP address of the Mobile VoIP unit
- Network > WAN Settings > Mask = Network mask
- Network > WAN Settings > Gateway = IP address of the network gateway
SIP settings
SIP Settings:
In SIP Settings > Service Domain, enter information for "Realm 1":
- SIP Settings > Service Domain > Active = ON
- SIP Settings > Service Domain > Display Name = Any text
- SIP Settings > Service Domain > User Name = Access number to the gateway
- SIP Settings > Service Domain > Register Name = Access number to the gateway
- SIP Settings > Service Domain > Domain Server = IP address of the AlphaCom
- SIP Settings > Service Domain > Proxy Server = IP address of the AlphaCom
Status = Registered: The gateway is registered at the AlphaCom.
- SIP Settings > DTMF Setting: Enable "Send DTMF SIP Info"
Limitations
Outgoing calls from AlphaCom:
- No DTMF tones can be sent from AlphaCom to the line during conversation (Nettbank kan ikke brukes).
- Digits during conversation (e.g. door opening, M-key) not possible from the phone