Difference between revisions of "FBSAR - PA interface"
From Zenitel Wiki
(→Installing the FBSAR board) |
(→Installing the FBSAR board) |
||
| Line 29: | Line 29: | ||
| 2-3 || Normal attenuation | | 2-3 || Normal attenuation | ||
|- | |- | ||
| − | | S3 Low/Loudspeaking || Channel 1 only | + | | '''S3 Low/Loudspeaking''' || Channel 1 only |
| + | |- | ||
| 1-2 || Lowspeaking | | 1-2 || Lowspeaking | ||
| + | |- | ||
| 2-3 || Loudspeaking | | 2-3 || Loudspeaking | ||
|- | |- | ||
| − | | S5 Dual Relay Control | + | | '''S5 Dual Relay Control''' |
| + | |- | ||
| Closed || Dual Relay control || Alphacom only | | Closed || Dual Relay control || Alphacom only | ||
| − | | RP2 Output level adjustment || Channel 1 only | | + | |- |
| + | | RP2 Output level adjustment || Channel 1 only | ||
| + | |- | ||
| || Adjusting PA volume | | || Adjusting PA volume | ||
|} | |} | ||
Revision as of 16:07, 1 December 2008
Contents
Calling through PA System
Feature Description
The AlphaCom can distribute audio through separate loudspeakers for announcements and music distribution. This audio can be distributed via an FBSAR board. When loudspeakers without amplification are used, there must not be more than 20 such loudspeakers in one system. Such loudspeakers can only be connected via a FBSAR board.
Equipment List
- AlphaCom System with desired station range
- PA system / additional loudspeakers
- Filter Board with Speech Adapter FBSAR 1009505000
One FBSAR can feed two speakers or two PA amplifiers from two subscriber lines.
Installing the FBSAR board
- Fasten the FBSAR board onto one of the mounting rails on the distribution field.
- Supply the board with 24 V and 0 V (GND) from the Power Distribution Board. Use a 1-pair ordinary installation cable for this purpose; the cable is not supplied with the board.
- Run the wires according to Figure 15-4. Audio output connection is done from the Subscriber Connection Board.
- Check the switch settings.
| Switch setting | Function | Comments |
|---|---|---|
| S2 Level Adjustment | Channel 1 only | |
| 1-2 | Additional attenuation | |
| 2-3 | Normal attenuation | |
| S3 Low/Loudspeaking | Channel 1 only | |
| 1-2 | Lowspeaking | |
| 2-3 | Loudspeaking | |
| S5 Dual Relay Control | ||
| Closed | Dual Relay control | Alphacom only |
| RP2 Output level adjustment | Channel 1 only | |
| Adjusting PA volume |