WK20 - Applications: Difference between revisions
From Zenitel Wiki
| Line 32: | Line 32: | ||
2-45 | 2-45 | ||
=Amplified Calling | =Amplified Calling with answer in separate microphone. Amplifier switched with M-key= | ||
[[Image:FIG WK 5 1.png|thumb|350px|Amplified Calling with answer in separate microphone. Amplifier switched with M-key]] | |||
2-47 | |||
=Amplified Calling; answer in sep LS/PA switched with M-key 2-49= | =Amplified Calling; answer in sep LS/PA switched with M-key 2-49= | ||
Revision as of 10:51, 3 December 2008
Amplified Calling Tone with answer in station
Feature Description
The audio signal of incoming calls can be amplified as an extra indication of the call. The feature require a station and a separate speaker for distribution of the amplified calling tone. It is not possible to answer the call through the separate speaker.
Operation
As a call is made to the station, the corresponding RCO triggers a relay which controls the amplifier, and makes it turn on. This is repeated for every calling tone if the station is in PRIVATE position.
Equipment List
- Loudspeaker
- Power Amplifier WK1000614100
- Multi Relay Board MRBD 1009970200
Installation
Wire the components as shown on figure 1.1.
Resistor R10 needs to be removed.
Programming
Amplified Calling without answer. Amplifier constantly on
2-41
Amplified Calling without answer. Amplifier switched with the M-key
2-43
Amplified Calling with answer in separate microphone. Amplifier constantly on
2-45
Amplified Calling with answer in separate microphone. Amplifier switched with M-key
2-47