1-3c. IP Stations – SoftClient (solution): Difference between revisions
From Zenitel Wiki
(Created page with "left|thumb|400px|System configuration <br style="clear:both;" /> === Exercise === *Text <br><br><br><br> ---- ===Related articles === * [[1-3c. IP St...") |
|||
| (21 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
[[File:1-3c config.PNG|left|thumb| | [[File:1-3c config.PNG|left|thumb|450px|System configuration]] | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
__NOTOC__ | |||
=== Install and configure the SoftClient === | |||
* Download the file '''SoftClientSetup.msi''' from e.g. [[Downloads|Wiki download page]] or from Partnernet, and install it on the PC | |||
* If not already done, change the IP address of the PC to 10.1.10.90, and subnet mask 255.255.0.0 | |||
* Start the SoftClient, and select '''File''' -> '''Preferences''', and set these parameters: | |||
[[File:1-3c solution1.PNG|thumb|left|250px|SoftClient: File -> Preferences window]] | |||
<br style="clear:both;" /> | |||
* '''Save Settings''' | |||
* Select '''Configure Audio Device''' to adjust speaker and microphone levels | |||
===Configure the AlphaCom XE=== | |||
*In AlphaPro go to '''Users & Stations''', and select physical number 40; 140 Station 40 | |||
*Use the section on the right and change the configuration as follows: | |||
[[File:1-3c solution2.PNG|thumb|left|400px|AlphaPro: Users & Stations window]] | |||
<br style="clear:both;" /> | |||
* Send the changes to the AlphaCom XE | |||
[[File:SendChg.PNG|400px]] | |||
=== Troubleshooting === | |||
* If the SoftClient does not register, check the following: | |||
** In AlphaWeb, System Configuration -> Filters, verify that port for '''IP Stations''' and '''VoIP Audio''' is enabled | |||
** In AlphaWeb, System Configuration -> Licenses, verify that there are licenses installed for the SoftClient | |||
<br><br><br><br> | <br><br><br><br> | ||
| Line 11: | Line 31: | ||
===Related articles === | ===Related articles === | ||
* [[1-3c. IP Stations – SoftClient (practice)]] | * [[1-3c. IP Stations – SoftClient (practice)]] | ||
[[Category: AlphaCom practice]] | |||
Latest revision as of 09:04, 30 June 2022
Install and configure the SoftClient
- Download the file SoftClientSetup.msi from e.g. Wiki download page or from Partnernet, and install it on the PC
- If not already done, change the IP address of the PC to 10.1.10.90, and subnet mask 255.255.0.0
- Start the SoftClient, and select File -> Preferences, and set these parameters:
- Save Settings
- Select Configure Audio Device to adjust speaker and microphone levels
Configure the AlphaCom XE
- In AlphaPro go to Users & Stations, and select physical number 40; 140 Station 40
- Use the section on the right and change the configuration as follows:
- Send the changes to the AlphaCom XE
Troubleshooting
- If the SoftClient does not register, check the following:
- In AlphaWeb, System Configuration -> Filters, verify that port for IP Stations and VoIP Audio is enabled
- In AlphaWeb, System Configuration -> Licenses, verify that there are licenses installed for the SoftClient