TCAS Connections: Difference between revisions
From Zenitel Wiki
No edit summary |
|||
| (19 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
[[File:TCAS Connections 1.PNG| | {{A}} | ||
This article | [[File:TCAS Connections 1.PNG|thumb|right500px|TCAS substation - Rear side]] | ||
This article describes connection details of the analog intercoms [[TCAS-1]], [[TCAS-2]] and [[TCAS-3]]. | |||
The | ==Wiring== | ||
The cabling from the AlphaCom server to the intercom station is star wiring. Two twisted pairs of wires are required. The maximum distance depends on the cable diameter: | |||
* 0.5 mm wires: 1.4 km | |||
* 0.6 mm wires: 2.0 km | |||
* 0.9 mm wires: 4.0 km | |||
The station line can be connected in to ways: | |||
* By means of an RJ45 connector at the rear side of the station, or | |||
* By using the plugable screw connector | |||
Connection using the RJ45 connector: | |||
[[File:WiringAnalogTCAS.png|thumb|left|800px]] | |||
<br style="clear:both;" /> | |||
{{note| The [[Station cable for 4 wire analogue station|station cable]] is not a 1:1 cable! }} | |||
For details on connection at the AlphaCom server side, see [[ASLT - AlphaCom Subscriber Line Board]] | |||
<br> | |||
== Second Call Button == | |||
The station is prepared for a second external call button (DAK 2). The button can be connected between the A-wire and the lower leg on D6 on the print (highlighted in the image above). | |||
[[File:TCAS Connections 2.PNG|thumb|left|500px]] | [[File:TCAS Connections 2.PNG|thumb|left|500px]] | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
[[Category: Turbine]] | [[Category: Turbine Connections]] | ||
Latest revision as of 11:51, 31 August 2018
This article describes connection details of the analog intercoms TCAS-1, TCAS-2 and TCAS-3.
Wiring
The cabling from the AlphaCom server to the intercom station is star wiring. Two twisted pairs of wires are required. The maximum distance depends on the cable diameter:
- 0.5 mm wires: 1.4 km
- 0.6 mm wires: 2.0 km
- 0.9 mm wires: 4.0 km
The station line can be connected in to ways:
- By means of an RJ45 connector at the rear side of the station, or
- By using the plugable screw connector
Connection using the RJ45 connector:
|
The station cable is not a 1:1 cable! |
For details on connection at the AlphaCom server side, see ASLT - AlphaCom Subscriber Line Board
Second Call Button
The station is prepared for a second external call button (DAK 2). The button can be connected between the A-wire and the lower leg on D6 on the print (highlighted in the image above).
