Difference between revisions of "IP-ARIO Restore Factory Defaults"
From Zenitel Wiki
m (1 revision imported) |
|||
| (2 intermediate revisions by one other user not shown) | |||
| Line 1: | Line 1: | ||
| − | [[File:IP-ARIOConfig10.PNG|thumb|right|400px|Front view]] | + | [[File:IP-ARIOConfig10.PNG|thumb|right|400px|iP-ARIO - Front view]] |
| − | To configure the IP-ARIO unit with Factory Default IP Settings do the following: | + | To configure the [[IP-ARIO]] unit with Factory Default IP Settings do the following: |
# Disconnect power to the unit. <br/> | # Disconnect power to the unit. <br/> | ||
# Reconnect power and within 5 seconds, use a pin to press and hold the pinhole Reset button (on the front right of the unit). | # Reconnect power and within 5 seconds, use a pin to press and hold the pinhole Reset button (on the front right of the unit). | ||
Latest revision as of 14:10, 5 February 2018
To configure the IP-ARIO unit with Factory Default IP Settings do the following:
- Disconnect power to the unit.
- Reconnect power and within 5 seconds, use a pin to press and hold the pinhole Reset button (on the front right of the unit).
- Keep the Reset button pressed until the CALL LED emits 3 slow flashes followed by 3 fast flashes as confirmation that the unit is reset. (Takes appr. 25 seconds)
- Release the Reset button.
The unit’s IP settings will now be reset to factory default.
| Factory default values | |
|---|---|
| Station Mode | AlphaCom |
| Station IP address | 169.254.1.100 |
| AlphaCom IP address | 169.254.1.5 |
| Username* | admin |
| Password* | alphaadmin |
* Software 01.06 and earlier: ADMIN/alphacom)