Difference between revisions of "CLEAR RCO"
From Zenitel Wiki
| (4 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| + | {{AI}} | ||
{| border="1" | {| border="1" | ||
|- | |- | ||
| Line 13: | Line 14: | ||
|- | |- | ||
|colspan="2"|Response: | |colspan="2"|Response: | ||
| − | |colspan="3"|[[ | + | |colspan="3"|[[CLEAR_RCO_OK]], [[CLEAR_RCO_FAILED]] |
|- | |- | ||
|} | |} | ||
| Line 19: | Line 20: | ||
[[AlphaNet_Data_Protocol#RIO_Protocol|Back to AlphaNet message list]] | [[AlphaNet_Data_Protocol#RIO_Protocol|Back to AlphaNet message list]] | ||
| + | |||
| + | [[Category: ACDP messages]] | ||
Latest revision as of 14:45, 3 October 2019
| CLEAR_RCO | 0x0015 | 21 | AMC 05.00 | |
|---|---|---|---|---|
| $CLR W1 | ||||
| Turn the given remote control output off. | ||||
| 1 | UINT2 | Output pin number | ||
| Response: | CLEAR_RCO_OK, CLEAR_RCO_FAILED | |||