Difference between revisions of "1-1a. Exchange startup (solution)"
From Zenitel Wiki
(→Cards:) |
(→Power:) |
||
| Line 9: | Line 9: | ||
===Power:=== | ===Power:=== | ||
| − | *Connect the power source to the plug on the back of the exchange, marked ''24 VAC IN'' | + | *Connect the power source to the plug on the back of the exchange, marked '''''24 VAC IN''''' |
*Connect the mains cable to the wall outlet | *Connect the mains cable to the wall outlet | ||
*Observe the exchange starting | *Observe the exchange starting | ||
Revision as of 23:20, 26 February 2011
Practice 1-1a:
Cards:
- Insert the ASLT card in position 1.
- Insert the AMC-IP card in position 7.
Power:
- Connect the power source to the plug on the back of the exchange, marked 24 VAC IN
- Connect the mains cable to the wall outlet
- Observe the exchange starting
Coldstart:
- Press and hold the coldstart button on the AMC-IP board
- Press the reset button on the power card briefly
- Keep the cold start button pressed at least 2 sec. after reset.
- The AMC status LED will blink green when the boot is ready.