Difference between revisions of "%paf"
From Zenitel Wiki
(Created page with "The '''%paf''' macro is used in the Event Handler to check failure state of PA interfaces in UDP group(s). ===Syntax=== '''%paf(udp)''' Return 0 if no PA interface with fa...") |
|||
| Line 9: | Line 9: | ||
===Examples=== | ===Examples=== | ||
%paf(3) - ''Return fault state of UDP group 1 and 2 (Bit 0 and 1)'' | %paf(3) - ''Return fault state of UDP group 1 and 2 (Bit 0 and 1)'' | ||
| + | [[Category: IP-ARIO]] | ||
Revision as of 16:05, 5 July 2011
The %paf macro is used in the Event Handler to check failure state of PA interfaces in UDP group(s).
Syntax
%paf(udp)
Return 0 if no PA interface with failure. Return 1 if any PA interface with failure state.
- udp: bitmap of udp flags.
Examples
%paf(3) - Return fault state of UDP group 1 and 2 (Bit 0 and 1)